The refilling of this cartridge is messy therefore it is advised that gloves should be worn and the place where refilling is done should be covered with a newspaper or some other absorbent material.
The following steps can guide you to an easy refill of your brother printer cartridges. The different models have little variations in the procedures other remaining the same.
Brother printer cartridge LC01C, LC01Y, LC01M and LC01BK (MFC 7000 series)
1. Place any absorbent material like a towel underneath before refilling the brother ink cartridges.
2. After filling ink in the syringe bottle remove the needle and put the cone shaped adaptor on it.
3. Find the hole in the cartridge through which the ink flows out and turn the exit port down facing your lap.
4. Slowly inject the ink from the syringe bottle into the cartridge until the ink starts coming out of the vent hole and is not foamy.
5. Now turn the cartridge the other way round so that the vent hole faces you and the exit port is towards your lap.
6. Put the needle back into the syringe bottle and inject the needle into the vent hole. Continue injecting till the ink comes out of the exit hole and stops foaming.
7. Leave the cartridge in this position for about ten minutes. Then repeat the 6th step and let it rest for another ten minutes.
8. Install the cartridge in the printer. If it has to be transported then an electrical tape can be used to cover the exit and vent holes but must be removed before printing.
November 28, 2010
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment